The Monument Masters 1215K-XV, 1315-XVE, 1315Longarm-XVL, 1222G-XXII and 1322Extended-XXIIE create similar bend radiuses to a Monument 2600K combi bender; in fact the 1222G has a slightly tighter radius that the 2600K combi bender, as this radius is tighter it creates a slightly different profile on the outside of the bend when compared to a combi. Pipe springs are just that. Springs which go in pipes. Putting a spring into a pipe before applying pressure to bend it, will stop the pipe kinking.

Place the Lever Arm over the positioned pipe and place the Lever Hook onto the Pivot Pins, ensure the Nylon Guide is seated.

Delivery Policy

The Monument Masters 1215K-XV, 1315-XVE, 1315Longarm-XVL , 1222G-XXII and 1322Extended-XXIIE create similar bend radiuses to a Monument 2600K combi bender; in fact the 1222G has a slightly tighter radius that the 2600K combi bender, as this radius is tighter it creates a slightly different profile on the outside of the bend when compared to a combi. We have included bending angles of 30 45 60 and 90 degrees on the XV and XVL 15mm versions and an additional 75 degree angle on the 22mm version; these are easily visible on the Former of each bender.

The 15mm pipe bender also known as tube bender is an essential part of the toolkit for any heating or plumbing engineer. It is well documented that soldered fittings and compression fittings interrupt the flow of water around a heating system. Bending of copper pipe ensures unrestricted flow of water and can also create attractive, crafted finishes on installations. We believe the 1215K-XV, the 1315XVE, the 1315Longarm-XVL, the 1222G-XXII and the 1322Extended-XXIIE are easier to use than a combi bender: The copper pipe is then placed under the hook across the top of the wheel former (5) and under the stay. lighter in the hand than a combi. The Monument combi weighs more than 4kg; the XV weighs 1.5kg; the XXII weighs 2.3kgWe posed this question through the Tooltalk App (see all the answers in the app available for iOS or Android AOS). throating occurs on testing with the XV, XVE (XVL) XXII, XXIIE as well as Monument 2600K and a Hilmor® GLM Bending pipes with a pipe bender is difficult. Its not actually difficult to bend the pipe, but bending the pipe in the right place is a different ball game. Working out the diameter of the bend and linking it to the place in the run where you want the bend to start and finish can only be done with practice and we would very strongly suggest you buy extra pipe to practice with. Mark the pipe where you want start of the bend. Position the pipe in the Former under the Retaining Hook. Position the start of bend vertically in line with the Pivot Pin.