micro:bit BBC MB V2 GO V2 Go - Complete Starter Kit

£9.745
FREE Shipping

micro:bit BBC MB V2 GO V2 Go - Complete Starter Kit

micro:bit BBC MB V2 GO V2 Go - Complete Starter Kit

RRP: £19.49
Price: £9.745
£9.745 FREE Shipping

In stock

We accept the following payment methods

Description

Insert the micro:bit into keyestudio micro:bit sensor V2 shield.Then connect the reed switch sensor to keyestudio micro:bit sensor shield. Shown as below diagram.

Insert the micro:bit into keyestudio micro:bit sensor V2 shield. Then connect the analog rotation module to keyestudio micro:bit sensor shield. Connect signal pin to P0, + pin to V1 header, - pin to ground. When the sensor detects the outside pressure, the resistance of sensor will change. Then through the circuit can convert the resistance changes into the voltage changes, output it on the signal end. Insert the micro:bit into keyestudio micro:bit sensor V2 shield.Then connect traffic light module to micro:bit sensor shield, separately connect R, Y,G pin to S2, S1,S0 pin header, GND pin to ground. Shown below.

Součásti Micro:bit Starter Kit

Read the value of signal end. The higher the water level, the greater the value. When the analog value is greater than 400, buzzer on the module will alarm. You should see the value is showed on the LED matrix of micro:bit. Or you can open the serial monitor of Arduino IDE to get the value. Like below figure shown.

A photoresistor or light-dependent resistor (LDR) or photocell is a light-controlled variable resistor. Its principal is very simple.

So in this experiment, we are about to use a water sensor and a buzzer module to detect the water level in the glass, if beyond level, buzzer should make an alarm.

But if use the micro bit main board to control the servo angle, we only need to set the control angle in the development environment. The corresponding pulse will be automatically set in the development environment to control the servo rotation. You should see the voice value is shown on the LED matrix of micro:bit. Or you can open the serial monitor of Arduino IDE to get the value. Shown below. Multiple Programming Languages】 This micro bit Kit supports Makecode graphical programming, JavaScript programming, Python, and other programming methods. Children can use programming to achieve what they want. This micro bit kit better improves children's interest in programming! Insert the micro:bit into keyestudio micro:bit sensor V2 shield.Then connect obstacle detector sensor to micro:bit sensor shield, connect Out pin to S0 pin header, + pin to V1 header, GND pin to ground. Shown below. If you're a beginner to the BBC micro:bit, then you may be wondering what you could possibly do with it. That's why we are here to tell you 10 things that a beginner can do with just a micro:bit and a couple of accessories.

BBC microbit In The Classroom:

So in this project, you will learn how to use a flame sensor and an active buzzer module to simulate the fire alarm system. In this project, we combine the project 2 and project 3. You will learn how to control the LED on the module blink for two times, then breath for two times, circularly. This time we use keyestudio 3W LED module, which has high brightness and can be used as illumination. In this project, you will learn how to use a vibration sensor and micro:bit to control an LED on and off. This sensor adopts the flexible nano pressure-sensitive material with an ultra-thin film pad. It is water-proof and pressure-sensitive.



  • Fruugo ID: 258392218-563234582
  • EAN: 764486781913
  • Sold by: Fruugo

Delivery & Returns

Fruugo

Address: UK
All products: Visit Fruugo Shop