pcs. Brass Tassel End Caps, Raw Brass End Cap, Cord Tips, Cord Ends Cord End Caps Size Leather, Cord Terminators, 3X7 mm. Hole 0,90mm. Before you disconnect any wires always test the wires and make sure that they are not live – you don’t know who installed it and if it’s installed properly so it’s better to be safe than sorry.

Sterling Silver Cord End Cap, 925 Silver Cord Ends, Bracelet Leather Cord End Caps, Hole 2mm 2.5mm 3mm 3.5mm 4mm 4.5mm 5mm Silver tone Crimp Ends, Cord Ends, Clam Shell Bead Tip, Ball Chain Connector, Chain Crimps, Gold Plated Findings (GB-3289) Before you start make sure you isolate the electrical supply before attempting to replace the switch. You will typically find your fuse board or MCB panel and trip the fuse which controls all the lights. Keep collections to yourself or inspire other shoppers! Keep in mind that anyone can view public collections - they may also appear in recommendations and other places. Undo the screws on your new switch where the wires will go – feed the main cable through the base and screw the base into the ceiling. Now you can connect the wires – just make sure you tighten the screws properly and if the earth wire is present that you put a sleeve on it and connect it to its place on the base plate. As you can see in this picture whoever installed it they never bothered connecting the earth to its place for some reason.

Took of bottom half of pull cord bathroom switch. Only 2 wires both brown came out when I took bottom off. Do I need to know which cable goes in where? Or is it just a case of 1 in com and another in L1 or L2 I.e. is there a difference in these 2 wires? Use a small flathead screwdriver to undo tightening screws and pull the wires out. Then unscrew the base unit which is mounted to the ceiling and remove the old unit. Now you are ready to install your new pull cord switch.