This is consistent with measurements made in Audio, High Fidelity and Stereo Review magazines when the Micro Ridge (Line) first arrived in the 80s. Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). including mounting hardware), which is what I've measured for my own VM540ML, the resonant frequency would be of 7.

With an elliptical stylus at 5kHz, this can run over 5% with a continued increase as the frequency goes up. If improved low frequency resonance was not the goal for the VM540ML, we are left to assume the issue was higher friction found in cheaper tonearms produced today.Standard model with a Microlinear stylus, comes pre-assembled with a lightweight aluminium headshell (AT-HS10). Use an external preamp, a powerful 2-channel power amplifier and a set of good quality loudspeakers. If I look at the differences from another perspective I can also say, that the old system “rocks” more with its focus on bass and mids and is maybe for some people the better option for Rock and Pop, if the S-distortion is not too obvious. I used my old alignment protractor, on which the inner groove position can be aligned with the device staying in place, and was pleasantly surprised that the VM540 ML’s fold-down stylus cover also served in setting the correct angle and overhang.

Some people say, that this Audio-Technica can sound harsh depending on the capacity of the cables and phone-preamp, but in my environment it sounds great. I sourced a hard to get new belt from Malvern Audio which was critical, as this broadcast standard deck has a wow and flutter of less than 0. from the right speaker (Monitor Audio Radius 90s on their lovely bespoke stands - see the photo), and the REL sub, on a glass table.A self-made man and audiophile, Hidéo Matsushita was the former Director of the Tokyo Museum of Modern Art. It was at about that time as well that Carlo began purchasing “Audio Magazine” on a regular basis and came to appreciate, in particular, the writing and reviewing of the late Leonard Feldman.

STR 151 has the RIAA emphasis placed before the cutting head, as would be the case for a normal LP would. The diamond looks like it might not be mounted quite straight, but the magnification of my loup isn't sufficient to be sure. A permalloy centre shield plate enables the effective separation of left and right channels, suppressing electrical crosstalk to below 40dB. On the bench, these produce lower harmonic and intermodulation distortion figures than older generation shapes that I’ve tested, using the same test LPs Carlo used.

The other older records that show the problem do not appear to be damaged, but, as the noise is usually at the beginning of a side, I think it likely that these carry very light surface damage caused by poor handling in the past. The Elliptical stylus was created in response to the demands of stereo while the 3rd generation shapes were developed for the short-lived RCA CD-4 quadraphonic LP. unique web browser id used to track data from Microsoft Bing and its services/functions connected such as Clarity. Then I dug out my copy of Mozart 41st Symphony by Kripps and the Concertgebouw on Phillips from the early 1970s - part of a boxed set.

That was the big surprise, as general wisdom suggests that it should have been the best, but it just sounded lifeless and muddy in comparison to the other 2. You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice.He had thereby re-established the connection, and the turntable did perform well, until recently, when the left channel failed once again. Before the CD-era I only used a very cheap record player with an integrated Mono-speaker and ruined my first records with it. These were very strong characteristics of the previous AT440MLa/b series and are accounted by the VM generator (unchanged between both families except the improvement of copper purity from PC-OCC to 6N-OFC) and by the mechanical parts (cantilever and ML tip unchanged as per specifications).