Comfyable Puffy Laptop Sleeve 13 Inch 14 Inch, Quilted Puffer Laptop Carrying Case for Women, Pillow Case Compatible for MacBook Air M1 M2, MacBook Pro 13 Inch 14 Inch, 13 in 14 in Cover, Rice

Product Information

The choice of whether to glue a piece of leather or a finishing metal decorative piece on the front of the flap is entirely up to you. Two pieces of main of dimensions of front of laptop + 2″ (my MacBook Air is 11.5″x 7.5″ so my pieces were 13.5″x 9.5″ each) On the lining of the flap mark the center spot for the Velcro to be added 1 inch from the lower edge of the flap piece, making sure it is positioned centrally on the fabric then pin the Velcro in position to the lining only. So ladies, let me know, do you want me to make you life easier and make you a laptop sleeve pattern calculator to do the math for you? Let me know in the comments below

Fold the fabrics along the base seam, so that the right sides face out. Fold up the base to meet with the two marks you have made on the lining. Because it is difficult to measure 0.4 of an inch I’m going to round the height up to half an inch so 13 + 0.5” + 2” = 15.5”. Reach in between the double fold at the base of the laptop bag and start pulling the fabric through so the right sides are showing. STEP 10: Press the diy laptop case Now bend over the flap and see where the Velcro you stitched on the flap meets up with the front of the bag. Mark the spot where the Velcro from the flap touches the front.Pin it to the outer fabric only. Now to calculate the length of the fabric I’ll take the depth of the laptop which is 9” + height 0.4” which adds up to 9.4 inches, but this needs to folded over and include the envelope style flap so I multiply by 2.5 and add the 2” seam allowance bringing the calculation to 9.4” x 2.5 = 23. 5” + 2” = 25. 5”.

Now unfold the fabrics and machine stitch each Velcro piece in the spot marked to the SINGLE layer of fabric. With right side to right side of lining and outer, pin together and stitch across the base only leaving an opening in the middle of around 3 inches (10cm).

Cut the fabric to the size of your laptop as described above. You will need one piece for the outer sleeve and one piece of felt for the lining. This laptop sleeve pattern does not use a fusible lining, making it even easier.

Fold down the outer fabric and up on the other side to line it up with the lining piece. There will be a double folded section in the laptop sleeve now.

So, my fabric should be 15.5 inches wide by 25. 5 inches long to accommodate my 13” MacBook Air laptop.Fold so the right sides face out and pin the base turning in the raw edges of the gap you have left, so it is smooth, then press with an iron on the base only. Trim the corners at a 45-degree angle at the base of the sides, so there is no excess fabric when it is turned, and across the corners of the flap. Below you will find my step by step DIY laptop sleeve tutorial with VIDEO instructions for all the visual learners.