We value your privacy
Another thing to note is that this should not be applied to glass, especially the windscreen. I am presuming this is due to it having the potential to cause judder to the windscreen wiper blades, as well as the windows moving up and down in the door.
Yes it is compatible with all of those products plus UHD Coating, Lifeshine Bodywork Gloss Shield, Ultra Deep Shine, Extra Gloss Protection and polar seal. We recommend leaving the coating for at least 24 hours after application before washing for the first time.Much like Extra Gloss Protection, Rapid Ceramic Spray should also not be applied to plastics or trim. That is why I apply the product to the middle of the panel and spread it out that way. This gives much better control when applying to areas which are close to the trim. For that reason, a microfibre cloth as opposed to a pad is a much better way to get full control and make sure that every part of the panel is covered. Results Since the doors are roughly the same size as half the bonnet, I used two sprays on them as well. On the roof, I split it up into four sections, and applied two sprays to each section. Rapid Ceramic Spray creates a tough, protective barrier for maximum resistance against the natural environment. Intensive Tar Remover product can be used to remove any Rapid Ceramic Spray accidentally applied to glass. The application is extremely easy, especially since this can be done when the product is wet or dry. During the application process, I opted to apply it when the car was dry. It was as simple as applying a small amount to the panel, and then spreading it across the paintwork with a microfibre cloth. I then flipped the cloth over for one final pass to ensure the product had been suitably worked in.
Polishing your car is a great way to fade small scratches and imperfections. Find out how with our handy guide. Step 2: Shake well. Work on wet or dry painted surfaces in an area no larger than a shoulders width apart. For dry cars: Spray sparingly directly onto paintwork or onto a clean microfibre cloth or applicator and spread. For wet cars: Spray sparingly directly onto paintwork and spread with an Autoglym InstaDry. Two to three sprays per panel is sufficient, no more than two on smaller panels. Scottish Highlands - AB36-38, AB55-56, FK17-21, IV1-39, IV52-54, IV63, KW1-14, PA21-40, PH19-26, PH30-41, PH49-50Faulty products will be replaced as soon as we are able to verify the fault and ship another to you. Rapid Ceramic Spray is compatible with all of Autoglym’s shampoos and wax products as well as the Polar Series. We recommend that Pure Shampoo is used as part of your regular on-going wash cycle and UHD Wax can be used to boost protection and finish periodically throughout the year. Avoid using abrasive products such as polishes as well as solvent based products like Intensive Tar Remover as they can reduce the longevity of coating. If you do need to use these products, apply Rapid Ceramic Spray to affected areas afterwards. Rapid Ceramic Spray should be applied on mild dry weather days with an optimum temperature between 10-25⁰C. Autoglym Rapid Ceramic Spray is one of two, spray on protection products from Autoglym, with the other being Aqua Wax.