Silverline Water Level 10m (633586)

Product Information

Step 5 – Mark Level Points – Before you start marking, the fluid in the pipe will not be flat, it will be concave as in the image below. You should agree with your help whether you are marking at the low point of the concave or the high point A water level is exactly what it sounds, it’s a form of level that utilises a principle of physics that water will always find its own level wherever it is placed. Tip water onto an uneven floor and it will always find the low spots for you.

Step 1 – Fix to First Object – First, hold the tube up to the first object and then using either tape or screws, tape it or position screws either side to hold it in place so the top of the tube is level with the top of the object The job of marking is best done between 2 people so that both ends can be marked, so bear this in mind.Fresh water tank probe is supplied with a gasket and mounting nut for fitting to a 60mm diameter hole in your water tank and the wiring harness connecting the probe to the test panel is 4m long.

A complete leak detection kit to help protect a basement area or other vulnerable area in the home such as laundry rooms, central heating systems or other water pipes, from unexpected water leaks. Including a LeakStop alarm panel, connection cables, 3 metre sensor tape and optional shutoff valve (sizes available between 1/2″ and 2″). Step 4 – Move to Level – Once it is settled you have achieved a level point between both ends of the tube, you can then move it up or down until the fluid meets the height required. The other end of the pipe will be at the same height. You can then place your mark Our collections by our couriers are happening as usual. As it stands, delivery times are not being affected too much. Please be aware though that Royal Mail and other couriers are sometimes prioritising essential items so please bear with us if your delivery takes slightly longer than expected. Using water as a level in this manner has been done for many thousands of years and by many ancient civilizations including the Egyptians when building the pyramids so in terms of being a trustworthy method, it’s about as good and reliable as it gets.Fresh water and waste tank level kit from CBE consisting of a tank test panel with coloured LED indicators, tank probes and wiring harness. This kit is ideal if you are retro-fitting a water tank or if you don’t have a level monitoring facility as part of your 12V control system. The LEDs light up when the test button is pressed and indicate FULL, 2/3, 1/3 and RESERVE. Step 2 – Hold to Second Object – Holding your finger over the top of the tube, take the other end down to the object where you need to mark a level and hold in a "near enough" position towards the top of the object In case of water loss, refill and adjust the device. Colours on images on different devices may vary. We cannot guarantee an exact match of the colour to the product.