TOSAI stove 241 A

Product Information

As for finding a good cheap supply of fuel for the future, I’m hoping that with all the people around here that use oil and get deliveries from tankers, I’ll have at least a couple of people I can either buy from at cost or get them to add extra to their delivery and fill my cans. Its very frustrating that directly below my bedroom window is a large tank thats almost full of the stuff, and it won’t be topped up for a very long time as its used so infrequently. The Inverter Heater 5086 is an incredible piece of Japanese Engineering. Above all, it is safe to use, but it also has a fantastic heat output, while remaining economically sound to run. One of the main advantages of a Zibro Paraffin Heater is its low fuel consumption. The heaters run on clean burning fuel especially formulated for Zibro Heaters. Fuel is available at many outlets such as reputable garden centres, DIY shops, online shops etc. Just one litre of fuel will typically warm up your room for up to five hours. Very easy to budget your heating costs. The heat it puts out is impressive and once to room has warmed up, I switch it to “MIN’ and it keeps the temperature around my desired level for most of the evening.

These types of heating appliance use extremely large amounts of Electricity and after several hours of use can soon work out to be prohibitively expensive, which then largely negates all of the savings made the previous night during the E7 / E10 period. In comparison, I’ve used gas bottle Calor heaters in the same building twenty years ago and had very noticeable amounts of condensation, so (purely in my own opinion & my experience) if these heaters do produce moisture, they don’t produce it in the same volumes as traditional Calor heaters. The fan convected inverter heaters with the electronic display require a mains supply, and consume around 800w for their pre heat cycle of the combustion chamber for around 2 minutes before they ignite. Similarly, using Tozane which has been poorly stored can cause issues too. If Tozane is exposed to temperature changes, condensation might build up in a container than has been opened. Fan assisted for rapid room warm up (Electric Fan requires 22 watts of Electricity, about the same as an energy saving light bulb)Simply turning the main dial to the right and push the igniter button, activating the “spark” or piezo element. In the 1970s old paraffin heaters without a doubt had a smell about them. However, with modern & old technology combined, todays Zibro Heaters are clean burning during operation when using correct C1 Class BS2869 fuel together with Laser or Double burner Zibros that literally burn the smell away. There will be a slight odour when first starting a Zibro and when shutting off a Zibro only if the correct Zibro fuel is used which acts also as a status indicator.

I currently buy Electricity during the ‘peak’ periods from Npower, at around 21 pence per KW/H (Edit: This would now be around 40p / Kwh in October 2023)

More Views

Paraffin Heaters Energy costs are continually on the rise, especially in times of political uncertainty. At the same time, traditional ways of heating our homes such as multifuel stoves are now more tightly regulated than ever. These and other factors have driven many householders to look for alternative ways to keep their homes warm as the winter weather sets in.

If you do decide to use standard heating oil in your inverter heater, then I do strongly advise filtering the kerosene into the heater tank using a “Mr Funnel” . The Mr Funnel filter will ensure that any dirt and rust particles are removed from the fuel and that any trapped water caused by bulk tank storage is filtered out which ensures longer periods between cleaning of the heater filter and also prevents the heater from showing an “E4” error warning (which indicates water contamination in the fuel). You can buy a Mr Funnel water and dirt filter from HereNot only are Zibro Paraffin Heaters very economic and user-friendly, they will also keep you comfortably warm. Many people compare the warmth provided by paraffin heaters to a cosy coal fire. A natural heat that is not dry unlike heat often experienced from a gas or electric heating. A typical specified Zibro Paraffin Heater will warm up the room to be heated to the desired temperature within around 5 minutes. E4 / E2 / E0 codes are displayed when contaminated fuel or poor combustion is detected. It’s caused by one of two things. The electricity companies know all about the limited effectiveness of storage heaters and because of these limitations know that there is a very real possibility that the majority of their E7 customers will require some form of top up heating at some point during the evening especially during the coldest mid winter months, at the times when the most expensive ‘peak rate’ periods will apply, and so are laughing all of the way to the bank. Requires 240v supply to power electronic ignition, thermostatic controls & electronic fan which blows out the heat. A 1600va / 2000va rated UPS would power the unit for quite a while – assuming that the heater was already running when the outage occured and only required 22w of power to run the fan etc.

Yes - I too had a cable run to my workshop (used to be a garage!) and to my shed - a 10mm armoured cable protected with RCDs and a cement fillet at the bottom of at the north facing wall. From my shed I ran a lightweight JoJo reel to the GH (cable clipped to the 6ft boundary wall & fused 1 amp.) This is used solely for powering my 3 electric propagators. I also ran another extension lead to run a fan heater from w/shop to GH on a thermostat to keep the GH at 7-10 degrees when there is a risk of frost. It has proved to be effective and relatively inexpensive to run, though the initial installation expense of the 10mm armoured cable from the house to my workshop (which I needed because of the amount of machinery & equipment I use in there) did make me think long and hard - but in those days I was running a business and common sense + safety dictated it had to be done. The benefit to me now I've retired is that I have all I will ever need as regards power supply in workshop and shed. Remove the fuel filter from under the heater tank and wash it in Tozane, using something like an old toothbrush to gently brush it. Don’t use anything which may seperate and further worsen the problem, e.g. a sponge, or tissue. Do not use water or any other products other than Tozane when washing. At maximum output (3.2KW) this Paraffin Heater will typically run for 10-15 hrs on the 5 litre fuel tank. When the tank nears empty an alarm sounds to remind you to refill. A manual fuel pump is provided with the heater for ease of refilling. Simply insert one end into your Inverter Heater tank, insert the other end into your fuel supply and after that press the manual pump until your tank is full. There are some tips for removing the odour of Kerosene on the internet, one is to run the Kerosene through a carbon filter before final filtering it with the Mr Funnel, another is to add a cup of Limestone Powder (Often known and sold as Calcium carbonate) to a Gallon container of Kerosene, let the powder settle to the bottom of the container for 3 – 5 days, and then filter out the powder before using. I have no idea how well this works, or even if it works at all as i’ve had no reason to do it myself, but there is no harm in giving it a try if you find the smell to be bad. Its a practice often used by those who use Indoor Kerosene lamps for camping, log cabins and on narrow boats, so there must be some advantage to doing it. Both heaters are still running ten years later, which would be remarkable longevity even when used with the recommended fuel.These heaters were popular domestic space heaters in places like Japan for decades before they became popular over here and one of their biggest selling points is the fact they are portable, and burn clean enough to not need an outside vent or flue. Of course, this fact also makes them close to, if not 100% efficient. Would I consider one for a Canal Boat Application myself? – Yes, provided the practical and safety measures I mentioned above were followed, and it was possible to open up most or all of the room space inside the boat to increase the heating (and ventilation) area. My heater has a certain “wiff” to it while its running and reminds me of an Airport Runway on startup and shutdown. I buy my Kerosene from a fuel broker in 20 / 25 litre drums, and I simply put some plastic sheet / old newspapers down on the sink draining board, and pump the fuel from out of the larger 25 litre container into the removable heater fuel tank via the Mr Funnel using the siphon pump. If you take your time using this method then the whole operation is clean and spill free, and it takes less than a few minutes to fill the fuel tank in this manner. The heater fuel tank has a small glass window in the side, so you can see the fuel level rise as you fill it, so there is no risk of spillage through overfilling.