Wärmer System M10 x 15mm Copper Tap Tails for Monobloc, Basin and Sink Mixers,Tap Tails Connector for Mixer Taps,Flexible Tap Tails Replacement

Product Information

Ensure that any compression fittings are tightened up sufficiently and you can then turn back on the water or open any isolation valves. The 10mm feed pipes screw into the underside of the tap and are then machined out to become 15mm copper tails ready for the connection of 15mm feeds. Please note that proof of purchase will be required to arrange a claim and/or to arrange a visit by one of our expert Bristan Care engineers. The monoblock is a very clever piece of design technology which allows both the hot and cold feed to enter the base, or block of the tap. If your basin is designed for a monobloc tap, it will have a single tap hole, so you don't have the option to convert to separate taps unless you change the basin.

Intatec Limited is committed to ensuring that products which we supply are not manufactured using any material sourced in Russia or Belarus. I always groan when I see a monobloc soldered in because it becomes such a pain to get it out again and after cutting it out you usually have to do a fair bit of rearranging of the pipework to put in the replacement. When closed, the slots in the upper disc are covered by the unslotted portion of the lower disc, and no water flows. We will only process your data in a fair and lawful way and your details will never be passed onto third parties. However, the area through which the water can flow is much less than that offered by a traditional tap washer being raised off its flat seating, so flow rate is less.

But it's a bit of a minefield actually as I've found that Victorian Plumbing and Tap Warehouse seem to list much higher flow rates than what the manufacturer's data sheets say in many cases.

The Intatherm safe touch thermostatic basin mixer tap, designed for both domestic and commercial applications. If you would like to change your settings or withdraw consent at any time, the link to do so is in our privacy policy accessible from our home page.It comes with extended lever handle making it particularly suitable for installation in any healthcare or disabled toilet room setting. Fitted with a 5 litre per minute flow regulator, this model offers excellent water-saving properties as well as a built-in self-draining spout to reduce the risk of bacterial growth from static water. As said never use a pipe slice on the copper tails the pipes are to soft,use junior hacksaw a file the end smooth if you use push fit. The copper tails that are supplied with monoblock taps are not designed to be cut (which is why they crushed when you tried the pipeslice on them). So if the base of the cistern is 2 metres above the floor, and the tap outlet 1 metre above you will have ((2 - 1) / 10) = 0.

With the washer in place the nuts can now be tightened onto the threaded bar and this is where the DIY enthusiast struggles. Designed and manufactured for all commercial applications where functionality includes; water saving; anti-vandal outlets; temperature limiting device; nickel free waterways, self draining spout to reduce risk of bacterial growth in static water. Finding a tap set genuinely capable of operating at very low pressure is your only hope without installing a pump. We and our partners use data for Personalised ads and content, ad and content measurement, audience insights and product development. It is slid over the thread and the other end twisted tight by putting a nail or something similar into the hole and turning.Clamoing ring with three fixing screws for a secure fix to the basin which will not come loose if installed correctly. Once the tap is in the hole with the flat washer or mounting plate placed over the threaded bars, the steel washer can be slid into place also.