Unlocked ZTE MF286D CAT 12 600mbps 4G+/LTE Home/Office Router (White). 2 x RJ11 Tel Ports. 2 x External Antennas. Works with any Mobile Network Sim Worldwide. 2.4/5GHz Wi-Fi + Bridge Mode (Renewed)

Product Information

Plug in your ZTE board to power, being careful as its unsheilded and free from its plastic housing but dont power it on just yet. Once we set up our 4G Hub router, we tried it in three different locations around the house, to find which place had the best 4G signal. The device is sold on a 24 month contract by Three, with no upfront fee, and a very reasonable monthly cost, compared to what you might pay for a regular home broadband connection that offers a similar download speed. Wi-Fi bandwidth is also a fraction of the theoretical value: between computers in the LAN and WLAN during testing it did not exceed 288 Mbit/s. Also, try to rotate the router to point in different directions, once you’ve found a good spot for it.

Band 3 can come with varying levels of bandwidth, and assuming carrier aggregation you might be looking at 100Mbps or more, or perhaps sub-50Mbps if it's just one carrier, or you're a long way from the site - or it's congested etc. I’ve been doing some reading and people are trying to get these working with openwrt which would be brilliant if it happens. I was using load balancing and while it mostly worked, it wasn't perfect and each firmware revision seemed to change the behaviour. After a few failed pings (their number can also be determined) resets the router to re-establish a connection.

Have not tried openwrt yet as without changing software on the actual modem I’d still have the problem of low upload with band 1 as primary. There is probably a way to fetch more details related to firmware ID for each partition via serial or AT command or maybee even if you view the source code while in firmware view you may see more details. When you enter into this contract, you’ll have an unlimited data allowance, just like with a fibre broadband connection. Odd quirk with mine, it seems after a few days it just loses connection/won’t pass traffic and needs a reboot. OK More information about cookies ipq40xx armv7 ipq4019 2flash 128nand 256ram 4port gigabitethernet 802.

I have a bluespot 5g, a large 4g panel antenna of an unknown brand (in its defence it’s massive, the coax is good quality and it gives good results - I got it on a clearance sale for 30 quid ish online where RRP was about 90 quid or so).

However I found another in /Bin/UPDATE/ which works, both are the same size but the CRCs are different. Once OpenWRT comes out for this thing thats what i'll be putting on, it'll far surpass this firmware. I assume that's what the config is due to the details reported by cell mapper and the speed I do get (60-80Mbps), I'm just wondering what is likely the maximum for the cell. You may not see speeds quite as fast as the maximums we were able to achieve with your Three 4G Hub. Suppose that's correct actually as then left side would be somewhat redundant especially with Three so I'd expect the HB to go atleast as low as 2100mhz maybee even 1800mhz.

Three’s 4G Hub (ZTE MF286D) supports download speeds of up to 600Mbps and upload speeds of up to 100Mbps. For the remaining two receive only I could only speculate, maybee they've just the same capability as the primary two shown here but with down only and no up capability https://www. out of 5 – although the speeds aren’t as fast as they are with the 5G Hub, the 4G Hub is a great way to get online with good download speeds at home.Kun käytät laitteesi nettiyhteyttä ZTE MF286- mobiilireitittimen kautta, avatessasi internet-sivuja (http://) näytölle ilmestyy ilmoitus joka kertoo uuden version olevan saatavilla. To get a better idea of what speeds you can expect with 4G home broadband, take a look at the Three network coverage map. Firmware is probably locked to Three in various ways, as well as SIM lock (which has been removed somehow) there must be a DNS lock. The Three 4G Hub has two antenna ports, which you can plug in external antennas, if you choose to do so. This includes passing VPN connections, static MAC-IP binding (MAC address must be “patched” manually or copy device lists), packet filtering, manual port forwarding, UPnP, DMZ zone.

OpenWRT is not officially supported as of yet, it's only showing up in the release candidates of 22. If you’re looking for something more portable to get online with when travelling, take a look at the Three Huawei 4G Plus MiFi device. Toimenpiteellä voit saada parannusta yhteyden toimintaan mikäli jokin tietty verkkotekniikka tai -taajuus on ruuhkautunut käyttöalueella. Having said that no matter what modem I have tried my connection just stays the same speed, even my Huawei B311 CAT4 modem gets 100Mbps. Previously using just the one bluespot antenna externally speeds would range from about 10-15mbit in extremely busy periods and up to about 65mbit in the early hours of the morning.home/scl/ci/workspace/Soft4_MF286D_H3GSE_CPE/build_folder/qsdk/build_dir/target-arm_cortex-a7_uClibc-1. Like I wrote we cannot test those bands in Poland and we do not have those bands even in our original gui.